Pipe Offset Calculator gives plumbers and pipefitters the four calculations they run every day — rolling offsets, simple offsets, drainage grade, and end-to-end cut lengths — with huge type you can read across the trench and a fraction keypad built for a tape measure, not a spreadsheet.
No subscription. No account. Works offline. Your data never leaves your device.
ROLLING OFFSET Enter the set (or rise) and roll, pick your fitting angle — 22½°, 30°, 45°, 60°, 90°, or any custom angle — and get true offset, travel, and run instantly, with a labeled diagram so you always know which number is which.
SIMPLE OFFSET Single-plane offsets: one measurement in, travel and run out, drawn to your actual fitting angle.
GRADE Drainage slope both directions: run + grade gives you the drop, or run + drop gives you the grade — in inches-per-foot and percent, with one-tap presets for 1/8″, 1/4″, and 1/2″ per foot.
CUT LENGTH & REFERENCE A plain-English takeout explainer, standard butt-weld elbow takeout rules, and a cut-length calculator: travel minus both fitting takeouts equals the pipe you actually cut. Plus a full sixteenths decimal-to-fraction table.
BUILT FOR THE JOBSITE
• Every measurement works both ways: feet-inches-sixteenths AND decimal inches — enter either, read both (27-3/16″ and 27.19″)
• Custom fraction keypad with 1/16″ steps and ±1/16″ nudge buttons
• Big result cards — tap any result to copy it
• Your numbers are saved automatically, per tab
• One-handed layout, haptic feedback, full dark mode
• 100% offline — works in the basement, the crawlspace, and the parking garage
Buy it once, use it every day.
