FeedbackGuard is an Audio Unit v3 effect that stops acoustic feedback before it ruins your performance. Whether you are singing live, speaking on stage, or recording vocals on iPad, FeedbackGuard listens for runaway howling and automatically places precise notch filters — so you can focus on the show, not the squeal.
HOW IT WORKS
FeedbackGuard uses PNPR (Peak-to-Neighbourhood Power Ratio) analysis combined with a growth check to tell real feedback apart from normal voice, speech, or room tone. When a howling peak starts to build, the plugin tracks it with parabolic peak detection and deploys an adaptive notch bank that reacts in milliseconds.
Designed for live use: attack and release times, suppression depth, and notch count are all under your control.
KEY FEATURES
• Real-time howling detection (PNPR + run-up check)
• Adaptive notch bank — up to 24 simultaneous notches
• Live spectrum display with active notch markers
• "Balanced" preset for safe, transparent defaults
• 3 user preset slots — tap to recall, hold to save
• Fine-tuned controls: Sensitivity, Notch Threshold, Suppression, Q, Attack, Release
• Optional harmonic tracking for stubborn feedback tones
• Optional spectral noise reduction for quiet passages
• Full bypass
GET STARTED IN SECONDS
1. Open your AUv3 host (GarageBand, AUM, Cubasis, and more)
2. Insert FeedbackGuard as an audio effect on your vocal or monitor channel
3. Tap "Balanced" for recommended live settings
4. Raise Notch Threshold if notches appear on voice or room tone
IDEAL FOR
• Live vocals and speech
• Rehearsals, worship, small PA setups
• Mobile recording rigs on iPhone and iPad
• Any situation where monitor feedback is a risk
COMPATIBILITY
• Audio Unit v3 (aufx) effect
• iPhone and iPad
• Works in any AUv3-compatible host
• Mono or stereo, sample rates from 8 kHz to 192 kHz
FeedbackGuard — Adaptive Feedback Suppressor by Norwin Palme.
